The IMX477 is a high-resolution sensor. Adding an IR-CUT filter lets the same camera handle daytime colour and night-time infrared. Chinneo's IMX477 12.3MP IR-CUT camera module pairs it with a 90 degree M12 lens and a built-in IR-CUT filter switch.
Key specs
Specifications
| Item | Details |
|---|---|
| Sensor | IMX477 (IMX477R), 12.3MP, 4056x3040 |
| Pixel size | 1.55µm x 1.55µm pixels, 1/2.3 inch optical format, rolling shutter |
| Lens | M12 lens, 3.95mm focal length, F2.0, 90 degree diagonal field of view |
| Focus | Fixed focus |
| IR-CUT | Built-in IR-CUT filter switch for day and night modes, switched by hand or by software through the Raspberry Pi GPIO |
| Interface | 22-pin camera connector |
| Module size | 38mm x 38mm |
| Compatibility | Supports only Raspberry Pi series boards and NVIDIA Jetson series development boards |
What is in the box
- The Raspberry Pi and Jetson boards shown in the illustrations are not included
Supported boards
It supports only Raspberry Pi series boards and NVIDIA Jetson series development boards. If your project runs on another platform, choose a different camera.
The two cables
The listing includes a 22/15PIN cable and a 22PIN cable. That covers boards with the larger 15-pin camera connector and boards with the smaller 22-pin connector.
Questions to settle before you order
- Frame rate, which is not specified.
- Cable lengths, which are not specified.
- Infrared lighting. The listing does not show an IR lamp, so plan your own for dark scenes.
See the IMX477 IR-CUT camera page for the full table.
This guide is based on the published specifications for this module. Chinneo has not run hands-on tests of this module.